SFN-20241219A No Recline Seat Procedure

  • 1 minute(s) read
Prev Next

TICO Document #: SFN-20241219A

Description of Procedure: No Recline Seat Procedure

Instructions:

  1. Slide seat all the way back and level the back of the seat.

    1. The rear of the seat should sit off of the window about 1 to 3 inches depending on the person. Check by sitting in the seat and seeing if it touches the window. Adjust by the appearance of the seat.

  1. Once seat is set pull the material down on the side and find the small notch in the metal.

  1. Take a 5/16” drill bit and drill to the side or just under the notch.

  2. Take a 3/8” tap and run it through the hole.

    1. You will need a 3/8” by 1 ¼” bolt with a washer and lock washer.

  3. Tighten down and the task is complete.