.png?sv=2022-11-02&spr=https&st=2025-06-26T11%3A56%3A52Z&se=2025-06-26T12%3A07%3A52Z&sr=c&sp=r&sig=sxZtUpYl1Nqe2QqjbMSUT0OSG%2BIXw%2FM3dSEAq104tNo%3D "Header(2).png")
TICO Document #: SFN-20231016C (formerly TES-235, TES-236)
Description of Procedure: Tighten the 3/8-16 hex head bolts that secure the cab shell to the cab floor
Units Affected: Any TICO 2017 series cab
Tools: •
Torque wrench capable of achieving 60 in-lbs. with 9/16” socket.
Combination wrench, 9/16”
3/8” drill bit and drill
Blue Loctite® 242®, or equivalent.
Planned Labor: 20 Minutes
Note: Once the unit has reached Station 650-03, the cab shell should be resting on the cab floor, with the floor clamp cushion and clamp bar in position.
Instructions:
Install the 3/8” mounting hardware.
Working from the front and center of cab, align the clamp, cushion, shell, seal and floor (see Figure #1) and insert the 3/8 bolts into the holes of the clamp, cushion, shell, seal and floor and continue for all remaining holes.
Note: Figure #1 is a 3D cross section of the parts stack up for the front flange. The side and rear flanges are similar to the front.
If the (4) front center bolts (see Figure #2) are not perpendicular to the cab floor, use the 3/8” drill bit and drill/reem through the mounting hole until these bolts can be inserted without any restrictions.
On the right-hand side of the cab, the second bolt from the front, apply the thread locker to the threads of the bolt as shown in Figure #3.
On the Rear Left-Hand side of the cab, add thread locker to the threads of the (2) bolts indicated in Figure #4.
Torque ALL (35) 3/8” bolts to 60 in-lbs. per the pattern in Figure #5.
